© Microhard Systems Inc. 183
5.0 AT Command Line Interface
AT+MCTPS
Command Syntax
Enable/Disable the Comport serial port. This port is
located on the front of the VIP4G and is labelled as
the SERIAL port. It is disabled by default allowing it
to be used for Console/AT Commands. If enabled it
can be used for data.
AT+MCTPS=<Mode>
Mode:
0 Disable
1 Enable
Description
Example
Input:
AT+MCTPS=0<enter>
Response:
OK
AT+MCTBR
Command Syntax
Set Comport baud rate.
AT+MCTBR=<Baud Rate>
Baud Rate:
0 300
1 600
2 1200
3 2400
4 3600
5 4800
6 7200
7 9600
8 14400
9 19200
10 28800
11 38400
12 57600
13 115200
Description
Example
Input:
AT+MCTBR=13<enter>
Response:
OK
To Next Page
Loading...
