Inside
Cut
1
Outside Cut
6
16
HOW TO USE
Resawing: You can resaw narrow stock in one pass without a bandsaw, planer
or flat-bed sander. CAUTION! Stock must be square before resawing.
Resawing stock thinner than 1/4”, or resawing wider
stock, can be achieved in two passes by setting the
saw blade slightly higher than one half of the width
of the stock in the rst pass. Flip the stock over and
nish with a second cut.
Suggestion: Resawing stock thinner than 1/4”
should be obtained from the outside cut.
A wooden spacer can be added to the Balance
Support (6) for stock wider than 2” (see Figure 3 on
Page 5). INFO: Watch the online video to see this
and many other techniques: microjig.com/worksafer
Resaw to 1/4” (Inside Cut) or thicker in one pass as shown in Figure 18.
Note Handle (1) location.
Figure 18
With one of the Side Legs removed, the
Center Leg (3) is registered against the
rip fence, and the Stabilizing Plate (7) of
a GR-200 holds the dowel against the rip
fence. You can also split a round dowel in
half. INFO: Watch the online video:
microjig.com/dowel
RESAWING
GROOVING A ROUND DOWEL
To Next Page
Loading...
