microjig GRR-RIPPER - Leg Selection for Cut Widths

14
HOW TO USE
WARNING! Always visually check to ensure that the Saw Blade Tunnel has enough
clearance for the saw blade to pass through safely before turning on the saw.
Use the 1/2” Leg (4) against the
fence for cutting width (Inside Cut)
of 5/8” to 3 3/16”. Use the Balance
Support (6) when stock is not wide
enough to be under the Side Leg on
the left. The Handle (1) is secured
more towards the right side of
the saw blade since no pressure is
required on the left side of the cut.
Fig 15
Outside Cut Inside Cut
Balance
Support
1/2” Leg
4
6
1
Figure 15
USING THE 1/4” LEG USING THE 1/2” LEG
Fig 14
5
1
Outside Cut Inside Cut
Rip fence parallel
to the saw blade
Always keep the
GRR-RIPPER in full
contact against
the rip fence
1/4” Leg
Saw Blade
Figure 14
Use the 1/4” Leg (5) against the fence for
cutting width (Inside Cut) of 1/4” to 5/8”.
Note the location of the Handle (1) above
the cut line in order to apply balanced
pressure to both sides of the stock.
GRR-RIPPER Quickstart Video available
online at microjig.com/worksafer