microjig GRR-RIPPER - Table of Contents

TABLE OF CONTENTS
Introduction ................................................4-5
Operation Precautions & Safety ................................6-8
Assembly .................................................9-11
How to Use ...............................................12-13
Using the 1/4” and 1/2” Legs ...................................14
Irregularly Shaped Stock .......................................15
Balance Support Spacer .......................................15
Resawing ....................................................16
Grooving a Round Dowel ......................................16
Bevel Cuts ...................................................17
Pattern Routing ..............................................17
Slotting .....................................................17
Control and Feed Long Stock ...................................17
GRR-RIPPER Accessories ....................................18-19
3