microjig GRR-RIPPER - Bevel Cuts; Slotting Operations; Pattern Routing; Feeding Long Stock

Fig 23
Figure 23
Saw blade at 45 degrees
Figure 20
Fig 21
Template
Workpiece
Flush Trimming
Router Bit
6
Figure 21
17
When bevel cutting from 0 to 45 degrees,
the GRR-RIPPER provides great control and
virtually eliminates binding. INFO: Watch
the online video: microjig.com/bevelcut
Use the Stabilizing Plate (7) of the
GR-200 as a second fence to box-in the
workpiece on the router table.
For stock longer than 16”, please use
two GRR-RIPPERs in a “leap-frog”
operation to continuously feed the
workpiece. INFO: Watch the online
video: microjig.com/leapfrog
Securely holds and guides a small workpiece
against a template without tipping over. Use
Balance Support (6) to stabilize the GRR-RIPPER
when working with narrow or small material.
BEVEL CUTS SLOTTING
PATTERN ROUTING CONTROL & FEED LONG STOCK
Fig 22
Use as second fence
Figure 22
HOW TO USE