OPERATION PRECAUTIONS & SAFETY
8
All components must be inspected for
damage and securely fastened before
every use. Stop using the tool if any
damage occurs.
Do not use this product while under
the inuence of drugs, alcohol or any
medication.
To clean this product, use denatured
alcohol (available in the paint
department of home improvement
centers) or 91% rubbing alcohol
(available at drug stores).
Do not use this tool if any of the
components are damaged. Contact
your dealer or the manufacturer for
replacement parts.
When not in use, store this product on a
at and clean surface.
The machine tabletop used in
conjunction with this tool must be
at and free from obstructions other
than the required fence and one
cutting element. The tabletop must
be reasonably level and below the
waistline.
You must have a sturdy and straight rip
fence with a at front surface preferably
at least 3” in height and square to the
table saw top. The rip fence must be
long enough to cover the entire depth
from the front to the rear of your table
saw top. The rip fence must also be
equipped with a locking mechanism to
secure it on the table saw top so that it
is parallel to the saw blade at all scale
settings. WARNING! DO NOT SKEW
THE RIP FENCE! The GRR-RIPPER is
designed to feed wood parallel to the
saw blade.
The rip fence should also be accurately
calibrated to a xed scale to secure a
precise cutting width setting.
A sharp and clean carbide-tipped saw
blade should be used with this tool for
ripping, unless otherwise specied.
A Zero-Clearance Throat Plate or insert
(ZCI) should always be used when
cutting narrow strips. INFO: Watch our
online video on how to install a Zero-
Clearance Throat Plate: microjig.com/zci
WARNING! Never wear loose clothing,
gloves, bracelets or other jewelry that
may get caught in the moving parts or
cutting elements.
MAINTENANCE
TABLE SAW PREPARATION
To Next Page
Loading...
