• “Dest” – destination field of a telemetry parameters packet.
• “Path” – APRS path (default value of WIDE2-2 will allow your device to be
digipeated by most nearby digipeaters), if you leave this field empty,
packet will be sent without path,
• “RF[min]“ – telemetry parameters packet transmit rate to RF (expressed in
minutes), packet will not be sent if this field is set to 0,
• “IS[min]“ – telemetry parameters packet transmit rate to APRS-IS
(expressed in minutes), packet will not be sent if this field is set to 0,
• “Telemetry data” – this group of fields defines settings telemetry data reports,
• “Dest” – destination field of a telemetry data packet.
• “Path” – APRS path (default value of WIDE2-2 will allow your device to be
digipeated by most nearby digipeaters), if you leave this field empty,
packet will be sent without path,
• “RF[min]“ – telemetry data packet transmit rate to RF (expressed in
minutes), packet will not be sent if this field is set to 0,
• “IS[min]“ – telemetry data packet transmit rate to APRS-IS (expressed in
minutes), packet will not be sent if this field is set to 0,
• “Telemetry project title” - this is a project name associated with the telemetry
station, sent in BITS message,
• “First telemetry data packet delay [min]” - delay for the first telemetry data
packet, it allows to gather data (especially for 10-min and 60-min report) after
device power-up.
• “Telemetry reports” - if disabled, no telemetry parameters or telemetry data
messages will be sent,
10.12.2. Telemetry reports / Analog channels
This Tab defines 5 analog channels available in APRS telemetry reports. You can
select many different sources for channels data, including external WXTelemetry module
data (M), other external devices data (E) and device internal data (I).
40
To Next Page