Microscan MicroHAWK MV-20 - Page 71

MicroHAWK MV-40 External Illumination Control and Wiring
Optics and Lighting
4
MicroHAWK MV-20 / MV-30 / MV-40 Smart Camera Guide 4-9
Wiring for Strobe Illumination (NPN)
Warning: Contact between Pin 5 (gray wire) and any ground or voltage source less than
or equal to 3.5VDC may cause erratic operation in this configuration. Contact between Pin
5 (gray wire) and any voltage source greater than 3.5VDC will damage the illuminator.
* Insulate Pin 5 (gray wire)
MicroHAWK MV-40
Connector A
Smart Series Illuminator
Connector
Smart Series Illuminator
Pin Signal Name
1 +24VDC
2 Trigger –
3 DC Ground
4 Trigger +
5 Dim
MicroHAWK (Connector A)
Pin Signal Name
2 Power
6 Output 3
7 and 12 Ground and Output Common
2 Power
No Connection* N/A
to
to
to
to
to
Optics and Lighting