Using Quick Calibration
Camera Calibration
3
v4.1.3, April 2012 Visionscape FrontRunner™ User’s Manual 3-9
using the Load Calibration Data From File option on the main
Calibration page, and then selecting the File Will hold Cal Data
for my Entire Job.
Note: You can only reload this data into an Job that has the same
number of Snapshots.
If you select this save option, FrontRunner™ displays the Save
Calibration for Entire Job dialog box. Type in a file name, click
Save, and then click Finished.
It’s important to understand that when Calibration is performed, the
data is stored in the Snapshot step(s) of the Job, so the Job needs to
be saved when done. You do not need to use the Save options on
this page unless you want to load the Calibration Data into another
Job, or unless you want to simply have a backup.
Using Quick Calibration
Use the following procedure to quick calibrate a camera:
1. Create your Job.
2. Place the calibration target under the camera.
3. Click
4. Adjust the exposure and focus.
5. Click again.
6. Click
FrontRunner™ displays the Calibration dialog box, as shown in
Figure 3–7.
To Next Page
Loading...
