Advanced Concepts
FrontRunner™
2
v4.1.3, April 2012 Visionscape FrontRunner™ User’s Manual 2-15
The FrontRunner™ window has four major areas in the Runtime view:
• Control Bar — This toolbar allows you to select Inspections with their
associated Snapshot (Camera views). There is a Camera view button
for the focused Inspection to add/remove Snapshot view while the
device (Smart Camera or GigE Camera) is running. You can select
the layout to determine how the views are to be arranged for a
particular Inspection. Use the Ctrl key to select multiple Snap Views.
• Snap View Area — This area displays the selected Snapshot views
for the Inspection based on the layout you select. You can zoom the
image, save graphics, and change the view refresh rate and freeze
mode by operating a drop-down menu in the Snapview of interest.
• Inspection View Area — In this area, you can display output datums
results and timing information. You can also show results associated
with this Inspection.
• Device View — In this area, you operate controls to define a set of I/O
buttons and status lights that monitor the device I/O or generate
virtual triggers for any Inspections running on the device, either one
shot or periodic (you enter the period).
Figure 2–7 shows four Snap views, with zoom buttons and drop-down
menus expanded.
To Next Page
Loading...
