Chapter 2 FrontRunner™
2-50 Visionscape FrontRunner™ User’s Manual v4.1.3, April 2012
3. Do either of the following:
a. If a DHCP server is available on the same physical network as
the device, then select Obtain an IP address automatically.
Note: The Smart Camera may take up to one minute to acquire a
new IP address.
b. If no DHCP server is available, select Use the following IP
address, and fill in the IP address and Subnet mask for the
device.
Note: Make sure the IP address and Subnet mask are compatible
with one of the adapters in the PC.
4. Click OK.
FrontRunner™ displays the “Login to device” dialog box.
5. Enter the user name and password for the camera.
6. Click OK.
The Smart Camera reboots automatically, and the changes take
effect.
Changing a Camera’s Password
Note: You’ll need the user name and password for the camera whose
password you want to change.
Use the following procedure to change a camera’s password:
1. Start FrontRunner™ by clicking Start > Visionscape > Visionscape
FrontRunner.
2. Click on the name of the camera whose password you want to
change.
3. Click Take Control.
FrontRunner™ displays the Login to Device dialog box.
4. Enter the user name (default is hawkeye) and password (default is
vision) for the camera.
To Next Page
Loading...
