MICROSENS 8 Port Gigabit Ethernet Switch User’s Manual
107
Function name:
Port Setting/Status
Function description:
Port setting/status is used to configure the trunk property of each and every port in the
switch system.
Parameter description:
Method:
This determines the method a port uses to aggregate with other ports.
None:
A port does not want to aggregate with any other port should choose this
default setting.
LACP:
A port use LACP as its trunk method to get aggregated with other ports also
using LACP.
Static:
A port use Static Trunk as its trunk method to get aggregated with other ports
also using Static Trunk.
Group:
Ports choosing the same trunking method other than “None” must be assigned a
unique Group number (i.e. Group ID, valid value is from 1 to 8) in order to declare
that they wish to aggregate with each other.
Active LACP:
This field is only referenced when a port’s trunking method is LACP.
Active:
An Active LACP port begins to send LACPDU to its link partner right after the
LACP protocol entity started to take control of this port.
Passive:
A Passive LACP port will not actively send LACPDU out before it receives an
LACPDU from its link partner.
To Next Page
Loading...
