MICROSENS 8 Port Gigabit Ethernet Switch User’s Manual
123
Fig. 3-59
Function name:
Email/SMS Configuration
Function description:
Alarm configuration is used to configure the persons who should receive the alarm
message via either email or SMS, or both. It depends on your settings. An email address or
a mobile phone number has to be set in the web page of alarm configuration (See Fig. 3-
60). Then, user can read the trap information from the email or the mobile phone. This
function provides 6 email addresses and 6 mobile phone numbers at most. The 24 different
trap events will be sent out to SNMP Manager when trap event occurs. After ticking trap
events, you can fill in your desired email addresses and mobile phone numbers. Then,
please click <Apply> button to complete the alarm configuration. It will take effect in a
few seconds.
Note: SMS may not work in your mobile phone system. It is customized for different systems.
To Next Page
Loading...
