MICROSENS 8 Port Gigabit Ethernet Switch User’s Manual
142
help
Syntax:
help
Description:
To show available commands.
Some commands are the combination of more than two words. When you enter this command,
the CLI would show the complete commands. Besides, the command would help you classify the
commands between the local commands and the global ones.
Argument:
None.
Possible value:
None.
Example:
MICROSENS# ip
MICROSENS(ip)# help
Commands available:
------------<< Local commands >>------------
set ip Set ip,subnet mask and gateway
set dns Set dns
enable dhcp Enable DHCP, and set dns auto or manual
disable dhcp Disable DHCP
show Show IP Configuration
------------<< Global commands >>------------
exit Back to the previous mode
end Back to the top mode
help Show available commands
history Show a list of previously run commands
logout Logout the system
save start Save as start config
save user Save as user config
restore default Restore default config
restore user Restore user config
To Next Page
Loading...
