MICROSENS 8 Port Gigabit Ethernet Switch User’s Manual
145
restore user
Syntax:
restore user
Description:
To restore the startup configuration as user defined configuration. If restoring default
successfully, the CLI would prompt if reboot immediately or not. If you press Y or y, the system
would reboot immediately; others would back to the CLI system. After restoring user-defined
configuration, all the changes in the startup configuration would be lost. After rebooting, the
entire startup configuration would replace as user defined one.
Argument:
None.
Possible value:
None.
Example:
MICROSENS# restore user
Restoring ...
Restore User Configuration Successfully
Press any key to reboot system.
save start
Syntax:
save start
Description:
To save the current configuration as the start one. When you enter this command, the CLI would
save your current configuration into the non-volatile FLASH. If you want the configuration still
works after rebooting, save the configuration using the command ‘save stat’.
Argument:
None.
Possible value:
None.
Example:
MICROSENS# save start
Saving start...
Save Successfully
MICROSENS#
To Next Page
Loading...
