Microsens MS453522M - Page 193

MICROSENS 8 Port Gigabit Ethernet Switch User’s Manual
188
 management
add
Syntax:
Usage: set [<name> <value>] [<vid> <value>] [<ip> <value>] [<port> <value>]
[<type> <value>] <action> <value>
Synopsis: set name Mary vid 20 ip 192.168.1.1-192.168.1.90 port 2-5,8
type h,s action a
Synopsis: set name Mary vid 20 ip 192.168.1.1-192.168.1.90
Description:
To save the adding management policy records.
When you don’t know how to set the management policy records, you can use this command as
follows:
MICROSENS (management-add)# set
This command will show exhaustive operating explanation for setting the management policy
records.
Argument:
[<name> <value>] ACL entry name.
[<vid> <value>] VLAN ID.
[<ip> <value>] IP range.
[<port> <value>] Incoming port.
[<type> <value>] Access type.
<action> <value> a(ccept) or d(eny).
Possible value:
[<name> <value>] No default and it must be set.
[<vid> <value>] The range is 1-4095 and can be set to any.
[<ip> <value>] For example, 192.168.1.90-192.168.1.90 or any.
[<port> <value>] For example, 1 or 1-8 or 1,3-5 or any
[<type> <value>] For example, h(ttp),s(nmp),t(elnet) or any.
<action> <value> No default and it must be set.
Example:
MICROSENS(management-add)# set name Mary vid 20 ip 192.168.1.1-192.168.1.90 port 2-5,8
type h,s action a
MICROSENS(management-add)# show
#: 1
Name : Mary VlanID : 20 IP : 192.168.1.1-192.168.1.90
Type : Http,SNMP Action : Accept Port : 2,3,4,5,8