调高器说明书
Dead zone: Within a certa in height range, the height of the cutting
head
will not be adj ustable any more. The range is called dead zone. If
the dead-zone range is set too wide, the control precision will be t oo
low; if it
is set too narrow, t he cutt ing head may oscillate up and down
easily. An appropriate value of dead zone will not only guarantee t he
control precision
but also generate no oscillation.
1.5 Contact Information of Manufacturer
Beijing Microstep Contro
l Technology Co.,Ltd.
Address:
Room 604, Zeyang Mansion, 166 Fushi Road, Shijingshan District, Beijing
Postcode：100043
Tel：086-10-88909150（telephone exchange）
Sales：086-10-88909235
Fax：086-10-88909277/1
Website：http://www.startsh.com/eng
Email: hzq_beijing@startsh.com
2. Overview
2.1 Technical Features
Stepper motor inst ead of conventional DC motor
Model SH-HC30 height cont roller fo r flame/pla sma cutting torch uses
the proprietary stepper motor control technology of Microst ep to
replace the conventional DC mot or height control technology, which
makes it faster and smoother in addition to significantly intended
service life.
Directly displaying the height of cutting nozzle in capacitance height
control mode
5
To Next Page
Loading...
Need help?
General
