调高器说明书
Usually, the I/O of the CNC system is in manual control mode of t he height controller.
When processing
starts, the I/O of the CNC system will turn t o aut omatic control mode of
the height controller. In such mode, the mecha nical lifting device of the height controller is
under automatic height control.
4.3 Operation via communication interface of CNC system (RS232
communication mode)
This feature is under development and will be amended aft
er the functions are completed.
4.4 Operation Flow
Flow starts
Arc
voltage
detection m ode
capacitance
For mechanical installation,
see 3.1 and connection of
capacitance sensor is
required.
For mechanical installation,
see 3.1 and connection of
capacitance sensor is
required.
For electrical connection in
arc voltage mode, see 3.3
For electrical connection in
capacitance mode, see 3.2
Power on and set the
detection mode to arc
voltage mode, see 5.1
and 7.1
Power on and set the
detection mode to
capacitance mode, see
5.1 and 7.1
The flow ends.
28
PDF 文件使用 "pdfFactory Pro" 试用版本创建 www.fine
print.com.cn
To Next Page
Loading...
Need help?
General
