MicroStep SH-HC30 - Controller

调高器说明书
Table 3-1 Pin definitions of 25-pin connector of CNC system for the height control system
Not e: The pins whose serial numbers are not listed of the 25-pin plugs of CNC
system will not be used.
Table 3-2 Pin definition of 15-pin connector of height Controller
16
PDF 文件使用 "pdfFactory Pro" 试用版本创建 www.fine
print.com.cn
S/N
Attribute
Description
5 Output Manual/automatic selective signal
6
Power
Supply
24V
g
round for power suppl
y
of
height
controller
7 Output
Manual lifting signal t o drive cutting
torch up
12, 13
Power
Supply
24 V positive for power suppl
y
of hei
g
ht
controller
19 Output
Manual descendin
g
si
g
nal to drive
cutting torch down
24, 25
Power
Supply
24 V positive for power suppl
y
of hei
g
ht
controller
No. Att ribute
Description
Remarks
1
Serial port fo r common use
232-COM
2 Serial port for Receiving 232-RXD
3 Serial port for transmiting 232-TXD
4
Input
Signal
Arc vo lta
g
e ( hei
g
ht of cut tin
g
torch) signal
5 Signal ground
Arc vo ltage signal ground