MicroStep SH-HC30 - Page 22

调高器说明书
Not e: The pins whose serial numbers are not listed of the 15-pin plug s of
the
CNC syst em will not be used.
17
PDF 文件使用 "pdfFactory Pro" 试用版本创建 www.fine
print.com.cn
7、14
Power supply
24 V positive for po wer suppl
y
of height cont roller
8、15
Power supply
24 V
g
round for power suppl
y
of height cont roller
10 Input
manual/automatic selective
signal
12 Input
Manual ascending signal for
driving the cutting torch up
13 Input
Manual descendin
g
si
g
nal for
driving the cutting torch down