MicroStep SH-HC30 - Control Operation of Electrical Operation Panel

调高器说明书
4. Quick Operation Guide of Height Controller in
Capacitance and Arc Voltage Modes
4.1 Cont
rol operation of electrical operat ion panel: (external switch mode)
For t he wiring of height controller in capacitance mode, see Section 3.2 -- "Electrical
Connection"
For the wiring of height controller in arc voltage mode, see Section 3.3-- "Electrical
Connection"
The operation procedure is as follows:
Set the automatic/manual control switch to manual mode
Set
the
Automatic
Cutting torch
control
割枪控制
升
Desce d
automatic/manual
control switch to
manual mode
Manual
2.Adjust the ascend/descend switch of the cutting torch as needed.
Automatic
Cutting torch control
割枪控制
Ascend
Adjusts the
ascen d/descend switch to
lift the cutting torch
Adjusts the
ascend/descend switch to
lower the cutting torch.
Manual
Automatic
Cutting torch
control
割 枪
Ascend
Descen
Manual
3.
Set the automatic/manual control
switch to
automatic mode
Set the au tomatic/manual
control switch to
automatic mode
Manual
Cutting torch control
割枪控制
Ascend
26
PDF 文件使用 "pdfFactory Pro" 试用版本创建 www.fine
print.com.cn
Automatic