MicroStep SH-HC30 - CNC System Interface Operation; Operation Flows; Operating Guide; Parameter Setting Procedures

调高器说明书
9 Description of Initial Location Function....................................................39
9.1 Positioning Mode................................................................................39
9.2 Setting of Positioni ng Heig ht .............................................................39
9.3 Process ................................................................................................39
9.4 Initial Arc Voltage Collection (Set Value A).....................................39
10 Instruction Functi ons Rela ted to M of CNC Sy stem and Height
Controller………………………………………… …………………………..40
10.1 Function M of Direct Control Output Port of CNC System .........41
10.2 Fixed Cycle of Functi on M .............................................................41
11 Remote height controller .........................................................................44
11.1 Function Introduction.....................................................................44
11.2 Operation Guide..............................................................................45
11.3 Wiring Instructions .........................................................................47
11.4 Installation Dimensions ...............................................................48
3
PDF 文件使用 "pdfFactory Pro" 试用版本创建 ww w.fine
p
rint.com.cn