Microtek ScanMaker i800 - Shipping the Scanner

ScanMaker i800 Supplement 5
Shipping the Scanner
If you have to transport the scanner, you will need to lock the scanner and TMA
back. Follow the steps below:
1. Turn off the scanner if your scanner is on.
2. Turn the scanner back on. The carriages of the scanner and TMA will move to the
standby position in a few moments.
3. When the lights on the front panel of your scanner stop blinking, push the
locking switch at the base of the TMA to the “Locked” position.
4. Push the locking switch at the bottom of the scanner to the “Locked” position.
5. Turn off your scanner. The scanner is now ready for transport.
Locked
Locked