Microtek ScanMaker i800 - Positioning Your Originals; Positioning Reflective Originals

ScanMaker i800 Supplement 9
Positioning Your Originals
Positioning Reflective Originals
To scan reflective originals such as photos and printed matter, use the Black Mat
which comes preattached to the scanner lid (TMA).
1. Raise the scanner lid, and make sure the Black Mat is attached to the scanner lid.
2. Place the reflective original face down on the scanner glass surface. Position the
top end of the photo towards the back of the scanner.
3. Lower the scanner lid.
Black Mat