ScanMaker i900 Installing and Getting Started 11
Caution:
Make sure that the Calibration slit faces the front of the scanner and keep it clear, free
from any obstruction when you insert the holder into the transparency bay (the drawer
or lower compartment) of the scanner.
Main Holder
4
"
x 5
"
Film Holder
B. By using the Main Holder, which is used together with the individual holders to
scan a particular type of standard-sized transparent film, such as individual 35mm
slides, 35mm filmstrips, 120 film, or 4" x 5" film.
Calibration slit
Glass Holder
Positioning Transparent Film
This procedure applies when you use the lower scan bed of the ScanMaker i900,
which has a holder that is used for scanning transparent film.
There are two ways to scan transparent film:
A. By using the Glass Holder, which is used to scan non-standard-sized transparent
film.
Vinyl strip
Calibration slit
To Next Page
Loading...
Need help?
General