Microtek ScanMaker i900 - Using the 35 Mm Slide Holder; Using the 35 Mm Filmstrip Holder

14 ScanMaker i900 Installing and Getting Started
A. Using the 35mm Slide Holder
The 35mm Slide Holder can hold a maximum of 12 mounted slides at a time.
1. Place the individual 35mm slides into the holder.
2. Place the slide holder in the Main Holder.
3. Insert the whole assembly into the transparency bay (the drawer or lower
compartment) of the scanner.
B. Using the 35mm Filmstrip Holder
Two strips of six frames can be mounted into the 35mm Filmstrip Holder at a time.
1. Place the 35mm filmstrip into the holder.
a) Push to open the lid.
b) Place the 35mm filmstrip into the holder.