10 ScanMaker i900 Installing and Getting Started
Positioning Reflective Originals
This procedure applies when you use the upper scan bed of the ScanMaker i900.
The upper scan bed is used for scanning reflective materials such as photos and
prints.
1. Open the scanner lid.
2. Place the original to be scanned face down on the scanner’s glass surface. Center
the top of the original along the horizontal ruler on the scanner.
Note: To scan a book or thick materials/documents, lift the scanner lid out of its
hinge sockets high enough to create room between the originals and the lid.
3. Lower the scanner lid.
R
To Next Page
Loading...
