Microtek ScanMaker i900 - Using the 4 X 5 Film Holder

ScanMaker i900 Installing and Getting Started 17
D. Using the 4 " x 5 " Film Holder
The 4" x 5" Film Holder can hold two pieces of 4" x 5" film at a time.
1. Place the film into the holder.
a) Push on the side to open the lid.
b) Place the film in the holder.
c) Pull down the side to close the lid.
2. Put the film holder into the
transparency tray.
3. Insert the whole assembly
into the transparency bay
(the drawer or lower
compartment) of the
scanner.
b)
a) c)