ScanMaker i900 Installing and Getting Started 15
c) Align the frame-by-frame
partition on your filmstrip with
the Arrow mark of the holder.
d) Snap to close the lid.
The partitions on the holder
should match the filmstrip’s
frame-by-frame partitions.
Frame-by frame
partition
2. Put the filmstrip holder into
the Main Holder.
3. Insert the whole assembly
into the transparency bay
(the drawer or lower
compartment) of the
scanner.
Caution:
When the filmstrips are closed, do not move or touch the filmstrips. If you do so, this
will bend the original that may result in out-of-focus scans.
To Next Page
Loading...
Need help?
General