40 Chapter 5: Mono Input Channel
VeniceF
Operator Manual
Group routing, which is post-EQ, post-mute and post-fader, can be configured in either
of two modes:
• Pre-pan (mono) Each group is sent the same mono signal, so that, for example,
selecting 1, 2 and 3 will send to each group equally.
• Post-Pan (stereo) Each pair of groups behave as if they were stereo groups. The
mono signal is positioned in a stereo field by the pan control. The left signal is
routed to the odd numbered bus and the right signal to the even numbered bus.
Selecting groups 1, 2 and 3 with pan hard left will result in the signal being routed to
groups 1 and 3 only. Similarly, with pan hard right, the signal will be sent only to
group 2.
This configuration is made by pressing the pan to groups button for stereo group
operation or released for mono group mode.
This selection, however, is on a channel-by-channel basis and so some may be assigned
to the groups as mono or as stereo, depending upon the desired usage. For example:
Application Configuration Reason
Submix Stereo Submix of drum kit.
Submix Mono Vocals with inserted compressor
(multiple vocals feed the same
compressor).
To Next Page
Loading...
Need help?
General
