70 Chapter 7: Output Section
VeniceF
Operator Manual
Recording
The two out (right and left) connectors are recording outputs. They are routed via the
stereo bus output and operate at a nominal -10dB. These outputs provide a direct
output from the console that is post-everything, including mute.
Local monitor and phones
There are two local monitor outputs on the rear panel for providing a signal for monitor
speakers.
Local monitor outputs on the rear panel
A local monitor section on the control surface lets you connect headphones for local
monitoring and adjust their signal level, and also the signal level of the local monitor
outputs.
Local monitor section on the control surface and the position of the addition
headphones socket on the front panel of the console
2 MUTE switch and red LED The MUTE switch mutes the input signal.
The LED illuminates to show when the mute is on.
3 SOLO switch and yellow LED The SOLO switch routes the input signal
to the mono PFL bus and stereo AFL buses. The solo LED illuminates to
show when solo is on.
Item Description
1 phones control knob Adjusts the headphones level, which is
continuously variable from
4 (infinity/off) to +10dB.
2 MUTE switch and red LED The MUTE switch mutes the headphone
signal. The LED is illuminated when the switch is on.
Item Description
To Next Page
Loading...
Need help?
General
