Service Manual_2023-V2.0
42
7.11 Main control board, Power board and Inverter driver board
Main control board, Power board and Inverter driver board
1) Dismantle the screw, then remove the PCB mounting
box cover.
2) Disconnect all the wiring connectors.
Method of disconnecting the connection terminals：
a. Use a needle tool to remove the lock at the arrow
and remove the lock upward;
b. After the lock is removed, press the hook to remove
the wiring connectors
3) Dismantle all the screws, then remove the Main
control board, Power board and Inverter driver board.
To Next Page
Loading...
