18
REMOVING COLLECTED WATER
Remove the cover.
Drain hose
Remove the plastic
cover rotating
counter-clockwise.
There are two ways to remove collected water.
1. Use the bucket
· When the unit is o,if the bucket is full, the unit will
beep 8 times(on some models) and the LED
DISPLAY shows “P2”.
· For some models, when the unit is on,if the bucket
is full, the compressor turns o and the fan turns
o after 30 seconds for drying the water of the
condenser , then the unit will beep 8 times and the
LED DISPLAY shows “P2”.
· Lift the dehumidifier body handle, separate the
dehumidifier body from the tank. Put the
dehumidifier body aside.
· Throw away the water from the water outlet and
replace the bucket.
NOTE:
· Lift the water bucket and throw away the water.
· Remove the rubber plug at the bottom of the
bucket, drain o the water.
· The machine will re-start when the bucket is
restored in its correct position.
· When you remove the bucket, do not touch any
parts inside of the unit. Doing so may damage
the product.
· Be sure to insert the dehumidifier body gently
all the way into the bucket.
· When you remove the bucket, if there is some
water in the unit you must make the unit dry.
1. Lift the dehumidifier by the handle,
separate the it from the bucket and
put it aside.
2. Lift the water bucket and throw
away the water.
· Water can be automatically emptied into a floor
drain by attaching the unit with a water hose.
· Remove the cover located on the back of water
bucket, then remove the rubber plug. Attach a
drain hose and lead it to the floor drain or a
suitable drainage facility.
2. Continuous draining
NOTE: When the continuous drain feature is not being
used,remove the drain hose from the outlet, reinstall
the rubber plug and cover.
· Make sure the hose is secure so there are no leaks.
· Direct the hose toward the drain area,making sure
that there are no kinks that will stop the warter
flowing.
· Place the end of the hose into the drain area and
make sure the end of the hose is level or downwards
to let the water flow smoothly. Do never let it up.
· Make sure the hose is lower than the drain hose
outlet.
· Select the desired humidity setting and fan speed
on the unit for continuous draining to start.
To Next Page