17
The dehumidifier can be used without bucket when
the unit is under Bucketless mode. The unit will not
reminds the water to be full after entering the
bucketless mode, therefore, it is suggested that:
Before you get start this feature
1. Check whether the tube is properly connected;
2. Link the other end of the tube to a place with
unlimited capacity, such as a sink or a basin;
3. Do not place the other end of the tube in a
container with limited capacity, otherwise the
water may overflow to the floor.
Exit the bucketless mode：
1. Press FILL LEVEL and up to exit
2. Turn o the power
NOTE
It may cause an unexpected exit from the bucketless mode when the tank float touches the
micro switch (at the bottom of the unit). So please check whether the bottom of the unit is
clear under the bucketless mode.
BUCKETLESS MODE
Function Introduction
Level and
smooth
ground
Tilt angle
Step 1: Please place the product correctly.
Please make sure the unit is placed on a flat,
horizontal table to prevent toppling and sliding.The
tilt angle needs to be less than 1 degree.
Step 2: Make sure the drain connection
is secure.
Please make sure the tube is properly connected to
the drain before entering the bucketless mode.
10cm
or more
Step 3: Make sure the hose has a height
dierence.
The overall height of the tube should be lower than
the drain to avoid water backflow and ensure
smooth discharge.
NOTICE:
At the Bucketless mode, the hight of table is
more than 10cm. Place the end of the hose into
the drain area or the container to catch
the water.
Step 4: Operation precaution.
On the Bucketless mode, don’t touch the switch or
the unit will exit Bucketless mode. Don’t move the
unit when it is working. Turn o the power and
remove the plug before moving the unit.
switch
To Next Page