CONNECT POWER CORD
W
ARNING
Electrical Shock Hazard
•
Plug into a grounded 3 prong outlet.
•
Do not remove the ground prong from the power cord
plug.
•
Do not use an adapter.
•
Do not use an extension cord.
•
Failure to do so can result in death, fi e or electrical
shock.
IMPORTANT: The power cord and connections must comply with the
National Electrical Code, Section 422 and/or local codes and ordinances.
Recommended cord length is 54" min. and 64" max.
1. Confirm th t power is turned off at the source.
2. Remove junction box cover. Retain for later use.
3. Install a UL listed/CSA approved strain relief.
4. Route power cord in the channel on the right-hand side of the
dishwasher base. Make sure that the dishwasher is not resting on and/
or pinching the wire.
5. Pull the power cord through the strain relief in the junction box.
a
a
Strain Relief
Safety
Precautions
Installation
Requirements
Installation
Instructions
24
To Next Page
Loading...
