© Midmark Corporation 2020
English - 27
TP202 20-42-FO-00014 Rev A1 C2169
003-1879-99
To clean/condition the handpiece push button and chuck...
(Applicable on ALL High-Speed Handpieces).
A) Screw push button chuck conditioner nozzle onto spout of a well-shaken can of
Midmark One Step Handpiece Cleaner/Conditioner using knurled base. Orient
curved tip of nozzle above can spout.
B) Insert nozzle tip into handpiece spindle bore/ (Where the Bur is inserted and
removed.) completely until it stops.
C) Hold very slight pressure on handpiece towards nozzle tip to keep it seated in
position. Direct handpiece and nozzle away from your body and towards an
absorbent towel. Depress handpiece conditioner can top to spray for a minimum of
two full seconds.
D) If overspray on the towel appears discolored repeat spray for an additional two
seconds. Remove handpiece from nozzle tip and wipe excess conditioner from
handpiece with a clean dry towel.
Re-attach handpiece and install a bur or bur blank. Run WITHOUT water for 45 seconds. Wipe o excess
conditioner with dry towel.
Nozzle
Midmark High-Speed Handpiece
Cleaning/Maintenance continued...
To Next Page
Loading...