© Midmark Corporation 2020
English - 26
TP202 20-42-FO-00014 Rev A1 C2169
003-1879-99
Attached to Handpiece
Conditioner Can
Swivel
Nozzle
Swivel
Swivel
Nozzle
To clean/condition the handpiece swivel coupler cavity...
(Applicable on Swivel High-Speed Handpieces Only).
A) Screw swivel nozzle onto spout of a well-shaken can of Midmark One Step
Handpiece Cleaner/Conditioner.
B) Remove swivel coupler from handpiece and Insert nozzle tip into handpiece where
swivel coupler was removed
C) Direct handpiece away from your body and towards an absorbent towel. Depress
handpiece conditioner can top to spray until conditioner flows from both ends of
handpiece head (1 to 2 seconds).
D) If overspray on towel appears discolored repeat spray for an additional two seconds.
Remove handpiece and wipe excess conditioner from handpiece with a clean dry
towel.
E) Remove swivel nozzle from cleaner/conditioner can and lightly spray o-rings of
swivel coupler. Re-install swivel coupler to handpiece.
Midmark High-Speed Handpiece
Cleaning/Maintenance continued...
To Next Page
Loading...