Cycled messages inform you that the battery is ready to
be put back into service: Good Battery / Top-Off
Charging / Hit STOP To End.
TOP-OFF CHARGE COMPLETION
When Top-Off Mode is complete, the charger will alert you
with an alarm and display the battery voltage, battery
condition, and the amount of charge put back into the
battery in amp-hours. The display will alternate between
the final results and a message to press ENTER
↵↵
↵↵
↵ for
the test code. (See “Test Code Generation.”)
The alarm will sound every 30 seconds, until the you
press the STOP button or disconnect the charger clamps
from the battery.
TEST CODE GENERATION
Before the charge session is finished the display will
alternate between the final results and a prompt to press
the ENTER
↵↵
↵↵
↵ button to generate the test code.
Press the INFO ( i ) button to print the test codes and the
final results. To return to the Mode selection screen and
start a new charge session, press the STOP button.
• 15 •
13.3V 9.4A Top-Off
Good Battery AH: 23.1
13.3V 9.4A Top-Off
Top-Off Charging AH: 23.1
13.3V 9.4A Top-Off
Hit STOP To End AH: 23.1
12.74V 0:45:16
Good Battery AH: 28.2
GR1-120 Charging Modes: Diagnostic Fast Charge
Test Code
↑↓↑↓
↑↓↑↓
↑↓
A1B2C 3D4E5 F6
To Next Page
Loading...
Need help?
General
