• 18 •
Chapter 4: Battery Testing
The tester will guide you through the steps of selecting your battery test parameters and interpreting the
results. Before you start the test, review the instructions in Chapter 3: Test Preparation.
Warranty mode
This test mode is speci cally designed for warranty claims. At the end of the test the tester can create a
testcode that is needed when the claim is issued.
1. Select the battery LOCATION.
OUT OF VEHICLE
IN VEHICLE
Press the
NEXT soft key to continue. The BACK soft key returns you to the Main Menu.
2. Select the POST TYPE. (IN-VEHICLE)
TOP POST
JUMP START POST
Press the
NEXT soft key to continue.
3. Select the VEHICLE (JUMP START POST)
TOUAREG
TOUAREG V10 TDI
By selecting a vehicle the tester will use a pre-de ned compensation factor to overcome the extra
resistance caused by the JUMP START POST cable. Selecting the wrong vehicle can lead to incorrect
measurements.
Press the
NEXT soft key to continue.
4. Select the TEMPERATURE.
Aim the tester 2 inches (5 cm) from the sides or top of the battery case. As soon as the temperature
reading is stable the operator can press NEXT
5. Select the BATTERY TYPE
REGULAR
AGM
2 * 6V SPIRAL
GEL
Press the
NEXT soft key to continue.
6. Press the
UP/DOWN ARROW keys to select the battery rating or in the case of JIS, the part
number.
Press the
NEXT soft key to start the test.
Chapter 4: Battery Test
To Next Page
Loading...
