• 39 •
Chapter 11: Troubleshooting
If you have problems with the display or printer try these troubleshooting suggestions:
Problems with the display
The display does not turn on:
• Check the connection to the battery.
• The analyzer’s internal batteries may need to be replaced.
The display ickers or is dim:
• The contrast may need to be adjusted in the Utility menu.
• The analyzer’s internal batteries may need to be replaced.
Data Will Not Print
The internal printer will not print
• The analyzer must be connected to the vehicle battery to print to the internal printer.
• The vehicle battery may be too low to power the printer. (Battery with at least 11.5 volts)
• Verify that the paper is properly installed
• Verify that the paper sensor is clean and undamaged
Chapter 11: Troubleshooting
To Next Page
Loading...
