• 31 •
6. Press the UP/DOWN ARROW keys to select the battery rating or in the case of JIS, the part
number.
Press the
NEXT soft key to start the test.
5. Enter the minimum voltage.
6. Select the TEMPERATURE.
Aim the tester 2 inches (5 cm) from the sides or top of the battery case. As soon as the temperature
reading is stable the operator can press NEXT
The tester will now test the battery.
After the test you can save the test result accompanied by VIN code information either by using the barcode
reader or manual input.
Chapter 7: QC Test
To Next Page
Loading...
