Miele CVA 6800 - Replacing the Angled Connector

Problem solving guide
89
Replacing the angled connec‐
tor
If, instead of being frothed, the milk is
only being heated up, check the follow‐
ing first:
– Is the milk in the milk flask cold
(< 10 °C)?
– Have the central spout and the milk
flask lid been cleaned carefully?
– Is the central spout correctly fitted?
If after checking the above, milk still
cannot be frothed, replace the angled
connector as follows.
You will need the replacement angled
connector supplied with the coffee ma‐
chine.
Do not use a needle or similar imple‐
ment. This would damage the com‐
ponents.
 Open the service flap on the back of
the appliance door.
 First pull the air intake tube  out of
the opening . Then pull off the el‐
bow connector .
 Pull both tubes out of the elbow con‐
nector.
 Clean the air intake tube  under
running water with the cleaning brush
supplied. "Blowing through" can help
to dislodge blockages.
 Insert the brush in the milk tube .
Move the brush back and forth as far
as possible until all milk residues
have been removed.
 Take the new angled connector (You
can dispose of the old angled con‐
nector with normal household waste).