Installation
96
Building in the coffee machine
Before installation make sure that
there is no power supply to the ma‐
chine. This also applies should it ev‐
er need to be taken out of its hous‐
ing unit.
The machine may only be operated
when built-in and in an ambient tem‐
perature range between +10 °C to
+38 °C.
You will need two Allen keys (size 3
and 5) for installing the machine.
To align the machine front with the fur‐
niture front, ensure that there is a seal‐
ing strip provided all the way around
the building-in niche or around the cof‐
fee machine.
If the housing unit niche is not fitted
with a sealing strip, you should fit a
Miele sealing strip to the machine be‐
fore installing it. This is fitted from the
back of the machine.
The sealing strip is available to order
from Miele.
Useful tip: We recommend providing a
place to sit the coffee machine which is
the same height as the building-in ni‐
che. This will make it easier to connect
the machine to the electricity supply.
Using the large allen key, unscrew all
four feet out by about 2 mm.
The feet can be unscrewed by up to
approx. 10 mm.
Connect the appliance to the electric‐
ity supply.
Ensure the mains connection cable
doesn't get damaged when pushing
the appliance into the niche.
Push the coffee machine all the way
into the building-in niche.
Check the height of the coffee ma‐
chine to make sure that it is sitting
centrally in the niche and that it is
level. If this is not the case, realign
the machine using the four feet.
To Next Page
Loading...
