Connector
The connector on the water container
consists of a valve insert, t, and an
O-Ring, u. There is also a connector
on the appliance itself, this however
only consists of the valve insert, t.
The valve insert and/or the O-ring may
need replacing if:
– an unusually large amount of water
collects in the bottom of the
appliance where the water container
connects to the valve.
–
a tone sounds and the symbol for
insufficient water is lit, even though
the water container is full and placed
correctly.
To replace the valve insert t
^
Insert the pointed end of the tool (see
"Accessories") into the valve insert
and pull the valve out.
From the water container, and
from the appliance.
Cleaning and care
46
To Next Page
Loading...
