Problem solving guide
58
Problem Cause and remedy
The compressor comes
on less and less often
and for shorter periods
of time. The
temperature in the
refrigeration appliance
rises.
This is not a fault. The temperature setting is too high.
Correct the temperature setting.
Check the temperature again after 24hours.
The frozen goods begin to defrost.
The room temperature is too low for this refrigeration
appliance.
If the room temperature is too low, the compressor
will run less frequently. This may cause the freezer
section to become too warm.
See “Installation – Location”.
Increase the temperature of the room.
Ice or condensation has
built up inside the
appliance.
The door seal has come out of its groove.
Check that the door seal is correctly positioned in
the groove.
The door seal is damaged.
Check whether the door seal is damaged.
The door seal is
damaged or needs to
be replaced.
No tools are required to change the door seal.
Change the door seal. A replacement is available
from Miele or from specialist retailers.
Frost has accumulated
on the front panel of the
NoFrost module.
This is not a fault. Condensation has settled on the
panel and frozen.
This could be due to:
– the appliance door being opened too often, or
being left open.
– a large amount of food is being frozen at once.
– an increase in humidity levels in the room.
Keep the door closed as much as possible. The
NoFrost system will automatically defrost the layer
of ice over the next few days.
To Next Page
Loading...
