Miele FNS 28463 E bb - Page 63

Problem solving guide
63
Message Cause and remedy
The symbol lights up
in the display and an
alarm sounds.
You have selected the “Cleaning position”
function, and the appliance has detected that the ice
cube drawer is full. The selected procedure is
interrupted and an alarm has sounded.
 Touch in the display.
The alarm message is confirmed and the warning
tone stops.
The current temperature will appear in the display
again.
 Empty the drawer, and then replace it in the
appliance.


lights up red in the
display and an alarm
also sounds.
There is a fault with the ice cube maker.
 To switch the alarm off touch

in the display.
 Call Service.
To report the fault you need the fault code and also
the model number and serial number of your
appliance. You can access these in the display.
 To do this touch in the display.
The appliance data required will be shown in the
display.
 Confirm withOK.
The ice cube maker can also be switched off in
Settings mode.