^
Place the funnel provided in place.
^ Carefully fill the reservoir with the
reactivation salt.
Some displaced water will run out - this
is normal.
^
Wipe any residual salt off the thread
and seal of the reservoir.
^
Screw the cap on securely.
^
Immediately after this step, start the
REMOVE SALT program, to remove
any traces of salt from the inside of
the machine.
Note: There may be a delay of a few
minutes before the REMOVE SALT
program starts due to the reactivation
of the water softener.
Water softener
17
To Next Page
