Miele G 7835 CD - Priming the Dispensing System

Priming the dispensing system
Before the washer-disinfector is used
for the first time, or if one or more
containers/dispensing systems were
not promptly refilled and became
completely empty, you will need to flush
the air from the dispensing system(s)
for processing chemicals. This is called
"priming". To do so:
^
Press the "ON/OFF" I-0 button.
^
Select operating level B.
^
Select one of the following:
DOS1-FILL program
DOS2-FILL program
DOS3-FILL program
DOS4-FILL program
(see "Operation/B/open program
selection").
^ Press the "Start" 6 button.
The service programs DOS-FILL are
factory pre-set to program slots
58-61 but can be shifted to other
program slots.
Servicing the dispensing
system
To keep the appliance functioning
properly, routine maintenance will need
to be performed.
This work should only be performed by
Miele Customer Service.
Every 12 to 18 months
Replace the dispensing lines in the
dispensing systems.
External dispensing systems
If external pumps are used for
dispensing, please contact Miele
Customer Service for information.
Follow the instructions under "Machine
functions" in the "Programming manual".
Adding liquid detergents and neutralizers
37