Please refer to the installation dia
-
gram supplied with the machine.
,
Furniture and fittings installed
near the machine must be of a com
-
mercial standard able to withstand
the effects of steam and condensed
water.
The machine must be installed correctly
and levelled.
Any unevenness in the floor level can
be compensated for and the height of
the machine raised or lowered by ad
-
justing the four screw feet.
The machine can be installed in the fol-
lowing ways:
^ Free-standing.
^ Slot-in or at the end of a row:
The machine can be installed next to
other machines or furniture or in a suit-
able niche. The niche must be at least
60 cm wide and 60 cm deep.
^
Built-under:
The machine can be installed under a
continuous worktop or sink drainer.
The recess must be at least 60 cm
wide, 60 cm deep and 82 cm high.
If necessary, the machine lid can be re
-
moved as follows:
^
Open the door.
^ Remove the fixing screws on the left
and right hand sides using a cross
slotted screwdriver.
^ Pull the machine lid approx. 5 mm
forwards, lift it upwards and remove
it.
Important for machines fitted with a
steam condenser (depending on mo
-
del):
To prevent damage by steam to the
worktop, the self adhesive protective
foil supplied (25 x 58 cm) must be
stuck in place underneath the worktop
near the steam condenser.
Installation
53
To Next Page
