To take out the back panel, side
liners (if fitted) and roof liner.
Make sure the oven heating ele-
ments are switched off and cool.
Danger of burning.
The catalytic panels can be removed
for cleaning if necessary.
See "Cleaning and care" for more infor-
mation.
– Back panel
Remove the runners.
Loosen the screws in the back panel
and take it out.
The oven must not be used without
the back panel fitted. This could
cause considerable injury.
Reassemble in the reverse order, care-
fully ensuring all parts are correctly in
place.
– Roof liner
Remove the runners.
Lower the top heating element.
Hold the roof liner firmly and un-
screw the knurled knob.
Take out the roof liner.
Reassemble in the reverse order, care-
fully ensuring all parts are correctly in
place.
– Side panels
(depending on model)
Take the telescopic carriage out.
Lift the side panels up a little and
pull them out of the oven.
Reassemble in the reverse order, care-
fully ensuring all parts are correctly in
place.
Cleaning and care
72
To Next Page
Loading...
